Get rid of those boxes and wires; and this is how you do it!

Description

It started with a sketch of a "front wall" to place the TV, Playbar and swivel bracket as optimally and inconspicuously as possible. Behind the wall are now the Ziggo media box, Apple TV4K, internet Hub. The electricity can be switched with KlikAanKlikUit sockets to control everything remotely. In the photo you can see that I adjusted the height afterwards, because it turned out to be optically too low. So take a good look at how high you would like it to be. I had to reorder, unfortunately. But it turned out fine. The sides were neatly mitered and fit perfectly. I built the whole thing from MDF Lakdrager 10mm. I covered it with a primer with 0.8 grit putty.

How did you realize your project?

The plates were reinforced at the back with corner slats (glued and screwed). Also placed some support beams on the bottom wall, so that the 157.0 cm x 235.0 cm plate has extra support. Both on both sides and at various heights, especially in the middle of the structure. Taking into account the free passage of wires and placement of other equipment and the swivel range of the Vogel suspension bracket. The case was secured in various places with parkers. The wall is further finished with alabastine to close the holes.

What are the external dimensions?

Final construction: Height: 185.0 + 50.0 cm x Width: 157.0 cm x Depth: 8.0 cm.
Free space behind the wall is therefore 7.0 cm.